23
Securing the vehicle
Emergency high-voltage shutdown procedure
1. Park the vehicle in a safe place.
2. Apply the park brake.
3. Turn the drive mode switch to 'N'
(neutral).
4. Remove the ignition key.
5. Press the emergency switch (1)
located next to the tachograph.
6. Exit the cabin.
7. Press the emergency switch (2)
located next to the high-voltage
charge plug behind the cabin.
8. Use the main switch (4) to turn OFF
the 24 V circuit.
9. Place the necessary and / or
mandatory warnings and wait on a
safe distance from the vehicle.
NOTE: In case it's not
possible to enter the cabin
perform step 7 till 9 of the
emergency high-voltage
shutdown procedure.
3.3 24V-BATTERIES
Location of the 24V-batteries
The 24V-batteries are located on the rear side within the chassis.
Disconnecting the 24V-batteries
1. Switch the ignition OFF.
2. Switch OFF the main switch (4).
NOTE: The manual main switch (4) can isolate the 24 Volt power supply
of the batteries from the vehicle. Only turn the main switch off, after the
ignition switch has been turned off.
D005278-2
1
2
3 4
5
DW83211801.book Page 23 Wednesday, February 12, 2020 11:04 AM