41
Towing information
6.3 TYRE INFLATING CONNECTION
NOTE: The tyre inflating connection can also be used as an external
inflating connection to fill the air pressure system with air from outside.
When doing this, check that the system pressure is correct using the air
pressure gauge.
The tyre inflating connection is located:
On the left-hand side of the cabin
behind the front panel.
WARNING! Always be
aware of possible moving
or rotating parts. For
example the cooling fans
while using the steps in
the front of the cabin or
working with an open front
panel.
– Moving or rotating
parts can cause
serious injury when
coming into contact.
Make sure that the supply pressure on the pressure gauges is not at maximum, but at
about 8 to 9 bar.
While inflating the tyres, keep the pressure on this value by having the air compressor
running.
See chapter 'Technical data and identification' for the correct tyre pressures.
Refit the rubber cap of the tyre inflating connection after the tyre has been inflated.
6.4 TOWING
WARNING! Switch off AEBS while towing or while being towed.
Engaging of this system during towing actions can result in unwanted
and unexpected vehicle behaviour.
WARNING!
– Do not tow the vehicle when fully loaded or with a trailer attached.
Towing a fully loaded vehicle or a vehicle with trailer attached can
result in unstable vehicle behaviour during critical driving situations.
This applies to both the towing and/or towed vehicle. This can lead to
very dangerous situations. High forces and tensions in the chassis
and driveline of the vehicles can also lead to damage to the vehicles.
DW83211801.book Page 41 Wednesday, February 12, 2020 11:04 AM
To Next Page
Loading...
