45
Towing information
1. Connect the NATO-connector.
2. Start the vehicle.
When the 24 V batteries were fully discharged, it is important that the NATO-connector
is not disconnected immediately. The vehicle must remain in operating mode for at
least 2 to 3 minutes before the NATO-connector is disconnected to prevent damage to
the electrical system (peak voltage!).
Proceed as follows as soon as the vehicle is in operating mode:
1. Switch on as many power consumers as possible (for example: headlights, fog
lamps, heater fan, and so forth).
2. Remove the NATO-connector.
3. Switch OFF the power consumers.
DW83211801.book Page 45 Wednesday, February 12, 2020 11:04 AM
To Next Page
Loading...
