When the ignition is switched off, the driveline automatically
shifts to neutral. If the service brake or park brake is not engaged,
the vehicle can move unintentionally. This can lead to serious
injury and damage to the vehicle.
– Always apply the service brake or park brake when the ignition
is switched OFF.
NOTE:
If the vehicles are equipped with Electronic Park Brake system (EPB);
See the section 'Brakes electronically operated' in the chapter Starting
and driving.
Follow the next steps when parking:
– Angle the front wheels so that the vehicle does not move into the traffic
stream if it is accidentally set in motion.
– Set the drive mode switch to N (neutral)
See section ‘Right-hand steering column switch’ in chapter ‘Controls’.
– Apply the park brake.
See section ‘Brakes electronically operated (Electronic Park Brake)’ in chapter
‘Starting and driving’.
– Test the trailer brakes.
See section ‘Brakes electronically operated (Electronic Park Brake)’ in chapter
‘Starting and driving’.
– Switch off the driveline by turning the ignition key to 0 (rest position).
– Stow-away the steering wheel.
See section ‘Adjust the steering wheel’ in chapter ‘Cabin'.
– Lower the seat using the quick down button.
See section ‘Suspended seat’ in chapter ‘Seats and safety belts'.
– When necessary, put wheel chocks in front of and behind the wheels of the
driven axle.
Ignition switch
0 Rest position
A Accessories position
D Drive position
S Start position
Securing the vehicle
16
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
To Next Page
Loading...
Need help?
General