3. Carry out this operation for each spring brake cylinder.
4. Bring the park brake back in operating order by turning the releasing bolts
clockwise as far as possible and tightening them to a torque of 70 Nm.
CAUTION:
It is advised to provide the vehicle with external air supply via the
Tyre inflating connection. See section 'Tyre inflating connection' in
the chapter Emergency repairs.
CAUTION:
EPB: Use the emergency release with or without external air sup-
ply via the Tyre inflating connection. See section 'Tyre inflating
connection' in the chapter Emergency repairs.
Do not use the workshop mode during towing.
6.1.3 Tyre inflating connection
Location
Make sure that the supply pressure on
the pressure gauges is not at maximum,
but at about 8 to 9 bar.
While inflating the tyres, keep the pres-
sure on this value by having the air
compressor running.
See chapter 'Technical data and identifi-
cation' for the correct tyre pressures.
Refit the rubber cap of the tyre inflat-
ing connection after the tyre has been
inflated.
NOTE:
The tyre inflating connections can also be used as an external inflating
connection to fill the air pressure system with air from outside. When
doing this, check that the system pressure is correct using the air pres-
sure gauge.
6.1.4 Towing
WARNING!
Switch off AEBS while being towed.
Engaging of this system during towing actions can result in
unwanted and unexpected vehicle behaviour.
WARNING!
– Do not tow the vehicle when fully loaded or with a trailer
attached.
51
Towing information
11
15
19
14
13
18
10
12
17
9
16
20
8
7
2
5
3
6
4
1
To Next Page
Loading...
Need help?
General