The maximum load the towing eye may pull is 40 tons.
NOTE:
To lift the vehicle two towing eyes must be used and both pins must be
perpendicular to the lifting cable or chain. Turn the towing eyes anti-
clockwise (maximum 180 degrees) to achieve this position.
Towing by a recovery vehicle
If the vehicle is being towed by a recovery vehicle, the vehicle can only be
hoisted under its rear axle. Lock the steering wheel in the straight-ahead posi-
tion.
WARNING!
If the electric motor remains connected during towing, the High-
Voltage components can be damaged and the High-Voltage gener-
ated by the electric motor can result in personal injury or death.
– Always disconnect the prop shaft before towing the vehicle
when the rear axle (drive wheels) is still in contact with the
road surface.
Tow starting
It is not possible to tow start an Electric Vehicle.
6.1.5 Jump-starting
Jump-start: Safety and warranty regulations
CAUTION:
Starting the vehicle using a starting aid with too High-Voltage can
damage electrical components and can cause the loss of warranty.
– Never jump-start the vehicle with a fast charger.
– Never jump-start the vehicle with a voltage higher than 29 V.
CAUTION:
Jump starting is only permitted with a starting aid equipped with
a mechanical main switch.
Do not disconnect the battery cables. Prevent at any times peak
loads on the 24 V installation.
Disconnecting the battery cables when the driveline is engaged
(ignition ON) can damage the electrical components.
Jump-start procedure:
1. Park the vehicle in a safe place.
2. Apply the park brake.
3. Turn the drive mode switch to 'N' (neutral).
Towing information
54
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
To Next Page
Loading...
