– Turn the ignition key so that the steering wheel is released (unless the
vehicle is in a hoist).
– If there is insufficient pressure in the air reservoirs, release the park brake.
See section 'Releasing the park brake'.
– To prevent damage to the electric driveline, always disconnect the prop
shaft from the differential.
WARNING!
If the electric motor remains connected during towing, the High-
Voltage components can be damaged, and the High-Voltage gener-
ated by the electric motor can result in personal injury or death.
– Always disconnect the prop shaft before towing the vehicle
when the rear axle (drive wheels) is still in contact with the
road surface.
NOTE:
If the differential is damaged:
– Hoist the vehicle at the rear and lock the steering wheel in the
straight-ahead position.
Installing the towing eye
1 Release the locking button.
2 Take away the cover.
Remove the front plate cover plate at the left-hand or right-hand side by pulling
it forward (A).
1 Remove the rubber cover.
2 Screw in the towing eye fully
so the entire thread is used.
3 Then turn the towing eye
anti-clockwise (maximum 90
degrees) so the towing bar
can be attached to the towing
eye.
53
Towing information
11
15
19
14
13
18
10
12
17
9
16
20
8
7
2
5
3
6
4
1
To Next Page
Loading...
