1 Charge port cover
1. Check if the charge port is clean and not damaged.
2. Check if the charge plug from charging station is clean and not damaged.
3. Plug the charge plug into the charge port.
4. Vehicle and charging station will initialise and the charge plug will be locked
to the vehicle.
5. If initialising is successful, the charging process will be started. The
remaining charging time can be seen on Digital Display.
1. When the target State of Charge of
the High-Voltage batteries is reached,
the charging process will be stopped
automatically.
2. Push the charge stop switch (1) on
the control panel to stop the charg-
ing procedure and unlock the charging
cable.
3. Disconnect the charging cable and
store the charge plug cable to the
charging station.
4. Close the cover on the High-Voltage
charge port.
19
Securing the vehicle
11
15
19
14
13
18
10
12
17
9
16
20
8
7
2
5
3
6
4
1
To Next Page
Loading...
Need help?
General