Chapter 11 Operation of Zigzag Embroidery
84 Owner’s Manual of BECS- A15 Computerized Control System
the parameters relating to the zigzag embroidery
.
1. Right Zigzag Device: Y (N) —— Y means the first needle is the zigzag embroidery
position.
2. Left Zigzag Device: Y (N) —— Y means the last needle is the zigzag embroidery
position.
3. Zigzag Device Move Time: 2 (Default Value) —— User should set this value
according to the actual action time of zigzag device.
4. Top Speed of Zigzag: 600 (Default Value). The top speed can be set to 850rpm, but
user needs set it on basis of the actual condition of machine.
5. Swing Range of Zigzag: 100 (Default Value). This value is the rotating angle of the
wheel. At the circumstance of thread-floating, user can decrease this value to relax the
influence as an assistant method. Generally, this value should be no less than 80.
6. Frame Swing of Z5 Embroidery: by adjusting the frame, user can change the
embroidery range (The senior users are recommended to use this parameter).
7. Zigzag Thread-loosing Adjustment Value: this is to adjust the thread-sending speed of
all the thread-loosing motors. The recommended value is 9.
8. Zigzag Right Device Origin: this is for the angle between the threading point and the
direction of the mechanical origin of zigzag device at first needle position. Angle =
Parameter value *0.9. For an example, the parameter value is 80; the angle will be
80*0.9=72°.
9. Zigzag Left Device Origin: this is for the angle between the threading point and the
direction of the mechanical origin of zigzag device at last needle position. Angle =
Parameter value *0.9. For an example, the parameter value is 80; the angle will be
80*0.9=72°.
10. Greateff mode: 5(1～5)
11. Work mode: 2(1～5)
12. Actuation time adj: 50(1～20)
13. Looped time: 50(30～100)
14. Whether cut line when jump: Yes/No.
To Next Page
Loading...
Need help?
General
