Chapter 11 Operation of Zigzag Embroidery
Owner’s Manual of BECS- A15 Computerized Control System 85
15. Thread-loosing Motor for Zigzag Embroidery: Yes/No. if the device is double motor
taping device, user needs to set it at “Y”, or user should set it as “N”.
16. Zigzag Device Movement Detection: Test whether the device moves to the proper
position. User needs set this parameter according to the actual condition of the device.
17. Test Thread-sending Motor of Zigzag Device (Y/N): The default value is “Y”. “Y”:
the thread-sending motor will not rotate until the position of hall component is
checked. “N”: The thread-sending motor will run as long as the system is at
embroidery status, regardless the position of the hall component. It can only be used
at the “107-P03-1.0” and higher version (for PC107 Board) or the “107B-JY-1.0 &
107B-DB-1.0” and higher version (for PC107B Board).
11.5 Relative Operations of Zigzag Embroidery
11.5.1. Shift between Flat Embroidery Position and Zigzag
Embroidery Position
(1) Manual Shift
In the main interface, press the key to enter into color-changing interface.
The indicates the embroidery mode of the current zigzag embroidery. Click that
To Next Page
Loading...
Need help?
General
