2 Device Installation
Note
Please make sure the installation surface can support at least 3X weight of the camera and
the bracket.
Please cut off the device power before installing Micro SD card.
Figure 2-1
Step 1
SD card installation (Optional)
Note
It needs to implement the step when the device is equipped with Micro SD card slot and it needs
to use Micro SD card.
1. Loosen the screw on the lower cover.
You can see the Micro SD card, analog output, two direction button and reset button after
you open the lower cover.
2. Insert the SD card into the slot which is shown in Figure 2-2, you can press the SD card
slightly to insert it because the card slot is elastic.
To Next Page
Loading...
