3 Bracket Installation Guide
3.1 General Bracket Installation
The housing can use the bracket of the thread hole to install. The general bracket thread hole
(M6) on the housing is shown as below. See Figure 3-1.
Figure 3-1
3.2 Special Bracket Installation (Compact design, concealed cable exit)
Step 1: Pull the cable through the inside of the bracket. See Figure 3-2.
Step 2: Secure the bracket on the housing. See Figure 3-3.
Step 3: Put the waterproof joint on the cables and then secure firmly. See Figure 3-4.
Figure 3-2
To Next Page
Loading...