2 Housing Installation Instruction Guide
2.1 Lock/Unlock Housing
You can use inner hex wrench (5.0mm) to fix or loosen the two M6 screws on both sides of the
housing to lock or unlock the housing. See Figure 2-1.
Figure 2-1
Important
Before you lock the housing, please make sure the waterproof gasket is in the right
position. See Figure 2-2. Otherwise it may affect the waterproof capability of the housing.
Figure 2-2
2.2 Camera Installation
Step 1: Take the camera bracket from the housing.
Step 2: Fix the camera on the camera bracket.
Step 3: Secure the camera bracket on the case. See Figure 2-3.
Note
To Next Page
Loading...