Local Configurations 126
Figure 5-87
Configure the settings for IP address, subnet mask, default gateway, user name, and Step 2
password.
Enable the Add function to add the device into the Added Device area. Step 3
Click OK to save the settings. Step 4
To modify IP address in batches, do the following:
In the Searched Device list area, select the devices that you want to modify IP address Step 1
in batches.
Click . Step 2
The Modify IP interface is displayed. See Figure 5-88.
Figure 5-88
Enable the Batch Modify function. Step 3
Configure the settings for start IP address (the IP address is allocated in sequence), Step 4
subnet mask, default gateway, user name, and password.
Enable the Add function to add the devices into the Added Device area. Step 5
Click Apply to save the settings. Step 6
To Next Page
Loading...