Alarm Control Panel Installer Manual
57
Customizing the Description of Access Code
You can customize the factory default description (Access Code no.) if needed.
On the access code submenu, for example, Access Code 2, press + 2 (F2) to enter the Step 1
editing status.
Press and to move to the position of the description, and then insert the character by Step 2
using the specific key (0 to 9).
Press to finish and save the description. Step 3
Press to exit from the submenu or press to continue. Step 4
DATE/TIME 1.32
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
DATE/TIME menu. See Figure 1-29.
DATE/TIME Figure 1-29
Press to enter the programming mode. Step 2
Configure the settings. See Table 1-27. Step 3
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
Table 1-27 Date and time settings
To Next Page
Loading...
