Alarm Control Panel Installer Manual
59
4: Holiday end month
5: Holiday year
Type in the value and press to confirm the setting, or press and to change the Step 4
value, and then move on to the next field.
Press to return to the holiday selection menu. Step 5
Then you can continue with programming other holidays, or press to return to the HOLIDAY
menu from where you can press and to move to the next menu or press to exit
from the Installer Menu.
To delete a Holiday, on the Holiday selection interface where the Holiday name is shown, press
and hold for at least three seconds.
TEL NUMBER 1.34
The TEL NUMBER menu is used to set the telephone numbers that will be used by the 2G/4G module for
voice calls and/or SMS.
Up to 8 different telephone numbers can be programmed for voice calls and remote control by dialing, 8
numbers for SMS and remote control by SMS. The same telephone number can be used for a different
number of voice calls/SMS (such as alarm, robbery, and 220V AC failure).
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
TEL NUMBER menu. See Figure 1-32.
Tel number Figure 1-32
Press to enter the programming mode. Step 2
There are three options: TEL NUM, SMS NUM, and SIM NUM. Press and to alter the
options.
TEL NUM
1) On the TEL NUM submenu, press to enter the interface from where you can select a
telephone number that you want to program by pressing and .
2) After selecting a telephone number, press to enter the programming mode.
3) Configure the telephone number settings. See Table 1-28.
To Next Page
Loading...
