Alarm Control Panel Installer Manual
60
Table 1-28 Telephone number setting
ACTIVE: Allow the telephone number to be linked.
ISOLATE: The telephone number is programmed but temporarily not
YES: When the alarm event occurs, if the event is programmed to link
multiple telephone numbers, press # key on your telephone to hang up
the call, the calling will not link to other telephone numbers.
NO: When the alarm event occurs, if the event is programmed to link
multiple telephone numbers, press # key on your telephone to hang up
the call, the calling will continue to call other telephone numbers.
Other functions:
Press + 2 (F2) to enter the EDITING mode for changing the telephone number. You
can type in up to a maximum of 24 digits. Use the horizontal cursor keys to move within
the number. Any of the digits can be overwritten. By positioning at any point in the number
(for example, at the start) and holding down , it is possible to delete all the digits from
that point onwards (for example, deletion of the entire number).
Press + 3 (F3) to do a test call on this number.
Press + 4 (F4) to interrupt the call in progress at any time.
4) Press to return to the telephone selection menu.
Then you can continue with programming other telephone number, or press to return to
the TEL NUM menu from where you can press and to move to the next menu.
SMS NUM
1) On the SMS NUM submenu, press to enter the interface from where you can select a
SMS number that you want to program by pressing and .
2) After selecting a SMS number, press to enter the programming mode.
3) Configure the SMS number settings. See Table 1-29.
Table 1-29 SMS number setting
ACTIVE: Allow the SMS number to be linked.
ISOLATE: The SMS number is programmed but temporarily not used.
Press 1 to 7 to select the day of the week when user wants to receive an
automatic SMS text about system status.
Press 1 to 7 to select the day of the week when user wants to receive an
automatic SMS text about pre-paid SIM credit.
To Next Page
Loading...
