Alarm Control Panel Installer Manual
62
MONITOR STATION 1.36
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
MONITOR STATION menu for digital Contact ID alarm centralization parameters (up to 3 Monitor
Station numbers). See Figure 1-34.
Monitor station Figure 1-34
Press and to select the monitor station that you want to configure, and then press Step 2
.
Configure the settings. See Table 1-30. Step 3
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
Table 1-30 Monitor station settings
ACTIVE: The PSTN number is enabled.
ISOLATE: The PSTN number is set but temporarily locked.
Set the digital protocol for each service center number (Only CONTACT ID
for now).
Set the date when to test PSTN.
Set the specific time when to test PSTN.
Press to return to the monitor station selection menu. Step 4
Then you can continue with programming other monitor stations (up to three), or press to
return to the MONITOR STATION menu from where you can press and to move to the
next menu or press to exit from the Installer Menu.
VOCAL MESSAGES 1.37
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
VOCAL MESSAGES menu. See Figure 1-35.
To Next Page
Loading...
