Dahua DHI-ARC3008C - Page 64

Alarm Control Panel Installer Manual
63
Vocal messages Figure 1-35
Press to enter the programming mode. Step 2
Press and to select the vocal message that you want to configure, and then press Step 3
.
Configure the settings. See Table 1-31. Step 4
Press and to alter the options. Press to confirm the setting and move to the next
submenu.
Table 1-31 Vocal messages settings
Submenu
Setting
STATE
ACTIVE: The alarm event links this vocal message.

ISOLATE: The vocal message linkage is programmed but temporarily

not used.
OFF: The alarm event does not link this vocal message.

CATEGORIES
Select a category from the following to link which you want to link the vocal
message.
AREA

ZONE

SYSTEM
