following. When the selected event is triggered, the 2G/4G module will
make a voice call to the choosen telephone number.
SYSTEM TAMPER:
SIREN TAMPER
ALARM MEMORY
FIRE
PANIC
ROBBERY
MEDICAL
DURESS
If select ZONE in CATEGORIES, configure the following settings:
LINK OUTPUT
By selecting the Output (01 to 40) with which the desired events
have been associated in advance, a specific non pre-programmed
call is set. For example, if vocal message 3 was to be used for the
wired zones 1 and 2 alarm, to achieve this, you need to program a
control panel OUTPUT in advance (see "1.26 OUTPUTS") (even if
the output module is not present on the bus) which follows the
ZONE condition for the Zone Alarm type which is associated with
the wire zones 1 and 2. Output 3 could be programmed in this
way. On the VOCAL MESSAGE menu, a message would then
need to be created to follow the ZONE event and output 3. In the
event of an alarm in wired zone 1 and 2, vocal message 3 would
then automatically sent the alarm voice call to the programmed
telephone numbers.
TEL NO: Select telephone number(s) that you want the vocal
message to link.
If you select SYSTEM in CATEGORIES, then you can select an event
Press to return to the vocal message selection menu. Step 5
Then you can continue with programming other vocal messages (up to 88), or press to
return to the VOCAL MESSAGES menu from where you can press and to move to the
next menu or press to exit from the Installer Menu.
Procedure to Enter in the Interactive Vocal Guide Menu
Call the 2G/4G module equipped with the Control Panel or receive a call from it. Step 1
When 2G/4G module is called and answer to voice broadcast "Please input the password."
To Next Page
Loading...
