User’s Manual
58
Figure 4-61 ITC push configuration
Step 2 Configure the parameters.
Table 4-31 ITC push
Enable
Select the Enable check box to push the passing vehicles
information.
No Plate Upload
Select the No Plate Upload check box to push the unlicensed vehicle
information.
Username
Username and password for logging to server.
Web URL Http URLprefix information of uploaded picture data.
Device ID Displays Device ID information.
Timeout of Http push message.
Keep Alive Time(s) You can set Keep Alive Time.
Character Encoding Encode mode of push content, which includes UTF8 and GB2312.
Select the type of list that you want to upload.
Push Picture Config
Select the pushed picture type, and it includes Original Image, Plate
Picture, and Vehicle Body Picture.
Upload Info Config Select the information that you want to upload.
Step 3 Click Confirm.
4.5.4 Event
This section provides guidance on configuring alarm and abnormality.
4.5.4.1 Alarm
4.5.4.1.1 Relay Activation
You can set several parameters of relay activation such as relay-in, period, anti-dither and
sensor type.
To Next Page
Loading...
Need help?
General
