Dahua DHI-NVR608R-64-4KS2 - Page 10

5
You can also configure network parameters in the Startup Wizard.
Figure 1-6 TCP/IP
Table 1-2 TCP/IP parameters
Parameter
Description
IP Version
In the
IP Version
list, you can select
IPv4
or
IPv6
. Both versions
are supported for access.
MAC Address
Displays the MAC address of the NVR.
DHCP
Enable the DHCP function. The IP address, subnet mask and
default gateway are not available for configuration once DHCP is
enabled.
● If DHCP is effective, the obtained information will be
displayed in the
IP Address
,
Subnet Mask
and
Default
Gateway
. If not, all values show 0.0.0.0.
● If PPPoE connection is successful, the IP address, subnet
mask, default gateway, and DHCP are not available for
configuration.
IP Address
Enter the IP address and configure the corresponding subnet
mask and default gateway.
IP address and default gateway must be in the same network
segment.
Subnet Mask
Default Gateway
Preferred DNS
Enter the IP address of DNS.
Alternate DNS
Enter the IP address of alternate DNS.