21
Select the check box. When an alarm occurs, the NVR device
sends an email to the set mailbox to notify the user.
You need to set the email first.
Select the check box and select the needed recording channel
(support multiple choices). When an alarm occurs, the NVR
device activates the channel for recording.
You need to enable intelligent recording and auto recording first.
At the end of the alarm, the recording extends for a period of
time. The time range is from 10 seconds to 300 seconds.
Select the check box and click Setting to select the channel and
PTZ action. When an alarm occurs, the NVR device associates
the channel to perform the corresponding PTZ action. For
example, activate the PTZ in channel one to turn to the preset
point X.
● Tripwire alarm supports to activate PTZ preset point only.
● You need to set the corresponding PTZ actions first.
Select the check box and select the channel for tour. When an
alarm occurs, the local interface of the NVR device displays the
selected channel screen.
● You need to set the time interval and mode for tour first.
● After the tour is over, the preview interface is restored to the
screen split mode before the tour.
Select the Snapshot check box to take a snapshot of the
selected channel.
To use this function, select
Main Menu
>
CAMERA
>
Encode
>
Snapshot
, select
Event
in
Type
list.
Select the check box to activate the buzzer when an alarm
occurs.
Check the box and then select the corresponding audio file from
the drop-down list. System plays the audio file when the alarm
occurs.
You need to add audio file first.
Step 3 Click
Apply
.
1.8 Live View
After you logged in, the system goes to multiple-channel live view mode by default. You can
To Next Page
Loading...
