20
Figure 1-21 SMD
Step 2 Select and enable a channel, and then configure parameters.
Table 1-6
The higher the value is, the easier it is to trigger an alarm. But at
the same time, the false alarm may occur. The default value is
recommended.
Choose human or motor vehicle or both.
Configure the period and in the set time range, the
corresponding configuration item will be linked to start the alarm.
Indicates the time taken from the end of motion detection to the
end of alarm linkage action. The range is 0 to 600 seconds.
The alarm device (such as lights, sirens, etc.) is connected to the
alarm output port. When an alarm occurs, the NVR device
transmits the alarm information to the alarm device.
When the alarm ends, the alarm extended for a period of time.
The time range is from 0 seconds to 300 seconds.
Check box to enable a pop-up message in your local host PC.
Select the check box. When an alarm occurs, the NVR device
uploads an alarm signal to the network (including the alarm
center).
● This function is available on select models.
● You need to set the alarm center first.
To Next Page
Loading...
