9
Table 1-3 Password
The default value is
admin
that cannot be changed.
The new password can be set from 8 characters to 32 characters
and contains at least two types from numbers, letters and special
characters (excluding"'", """, ";", ":" and "&").
Enter a strong password according to the password strength bar
indication.
3. Click
Next
.
4. Enter an email address and click
Next
.
Figure 1-11 Set email information
Step 5 Configure camera IP address.
● Select
DHCP
if there is a DHCP server deployed.
● Select
Static
, and then input IP address, subnet mask, default gateway and
incremental value.
Set the incremental value when you need to change IP addresses of multiple
cameras at one time. The NVR will incrementally add the value on to the fourth
section of the IP address when allocate IP addresses for those cameras.
To Next Page
Loading...
