Dahua HD IR Vandal Proof Network Dome Camera Quick Start Guide
2.1 Install SD Card (Optional)
Note
Please install SD card if the device is equipped with SD card slot and it needs to use SD card.
Please cut off the device power before installing Micro SD card.
Step 1
Use wrench to loosen the locking screws on the cover and then open the dome cover. You can see
SD card slot and reset button after you open the cover, which is shown in Figure 2- 1.
Figure 2- 1
Note
Please long press the reset button for 10 seconds with power on if it needs to restore factory
default setting.
Please press reset button for 1~2 seconds with power on and press WPS button of the router if
the device needs to use WPS function. Generally the device can be connected to corresponding
router within 1 minute (only supported by some models).
Step 2
Open card slot, adjust the direction of SD card, and install the SD card into the SD card slot.
Step 3
Close the SD card slot and lock it firmly.
Note
The following installation figure is for reference only; please refer to the actual device for more
details.
The device mounting surface needs to sustain at least 3x weight of the bracket and camera.
To Next Page
Loading...
Need help?
General
