Local Basic Operations 154
Table 4-29
Set the tripwire direction, including A→B, B→A and A↔B.
Click to filter the target. Check the blue wireframe and adjust the size of
the area with the mouse.
Each rule can set 2 target filters (maximum size and minimum size), that is,
when the passing target is smaller than the minimum target or larger than the
maximum target, no alarm will be generated. The maximum size should not
be smaller than the minimum size.
Select AI recognition and the system displays alarm target. The default
selection is person and motor vehicle and system automatically identifies the
person and motor vehicle appeared within the monitoring range.
When you select IVS of AI by camera, the connected channel shall support
tripwire function.
1) Press and hold down the left button on the monitor screen to draw the line. The line
can be a straight line or a curve.
2) Click OK to complete the rule setting.
Step 3 Click .
System displays the Trigger interface. See Figure 4-136.
Figure 4-136
To Next Page
Loading...
Need help?
General