Local Basic Operations 259
Quick detect is to detect via the universal system files. System can quickly complete the
HDD scan. If you want to use this function, make sure the HDD is in use now. If the HDD is
removed from other device, make sure the HDD once storage the record files when
installed on current device.
Global detect adopts Windows mode to scan. It may take a long time and may affect the
HDD that is recording.
4.13.6.1 Manual Detect
Step 1 Select Main Menu > STORAGE > HDD DETECT > Manual Detect.
The Manual Detect interface is displayed. See Figure 4-226.
Figure 4-226
Step 2 In the Type list, select Key Area Detect or Global Detect; and in the HDD list, select
the HDD that you want to detect.
Step 3 Click Start Detect.
The system starts detecting the HDD and displays the detection information.
When system is detecting HDD, click Stop Detect to stop current detection. Click Start
Detect to detect again.
4.13.6.2 Detect Report
After the detect operation, you can go to the detect report to view corresponding information.
Replace the malfunction HDD in case there is data loss.
To Next Page
Loading...
Need help?
General