Need help?Do you have a question about the Dahua VTO6210B and is the answer not in the manual?
General| Audio Output | Built-in Speaker |
|---|---|
| IP Rating | IP65 |
| Operation System | Embedded Linux |
| Camera | 1/3" CMOS sensor |
| Lens | 3.6mm |
| Night Vision | Support |
| Audio Compression | G.711 |
| Two-way Talk | Support Dual-way Talk |
| Network | Ethernet |
| Protocols | TCP/IP |
| Video Standard | H.264 |
| Frame Rate | 25fps |
| Alarm Interface | 1 |
| RS485 | 1 |
| Network Protocol | TCP/IP |
| Tamper Switch | Yes |
| Power | DC12V |
| Power Consumption | Max. 7W (IR on), 5.5W (IR off) |
| Wiegand Output | Wiegand 26/34 |
| Card Capacity | 10000 |
| Operating Temperature | -30°C to 60°C (-22°F to 140°F) |
| Connectivity | Ethernet |
| Display | No built-in display |
Key steps for securing the system.
Conditions and restrictions for device installation and use.
Specifications for power supply and wiring.
Step-by-step instructions for installing various VTO models.
Initial setup steps for the VTO device.
Setting up IP address, subnet mask, and gateway.
Setting up the SIP server for intercom functionality.
Instructions for downloading and installing the mobile app.
Steps to add and connect the VTO to the mobile app.
To Next Page
