Daikin Altherma 3 H MT ECH2O - Page 51

5 | Operation
User reference guide
51
ETSH/X(B)12P30+50EF
Daikin Altherma 3 H MT ECH₂O
4P663480-1 – 2021.07
c Smartphone + app The Daikin Residential Controller app needs to be
installed on the user's smartphone. See:
http://www.onlinecontroller.daikineurope.com/
Configuration
To configure the Daikin Residential Controller app, follow the in-app instructions.
While doing this, the following actions and information are needed on the user
interface of the indoor unit:
D
Wireless gateway
Malfunctioning
Operation
User profile
Room
[D] Wireless gateway
[D.1] Mode
[D.2] WPS
[D.3] Reboot
[D.4] Device info
[D.1] Mode: Turn AP mode ON (=WLAN module active as access point):
1 Go to [D.1]: Wireless gateway > Mode.
2 In the Enable AP mode screen, select Yes.
[D.2] WPS: Connect the WLAN module to the router:
1 Go to [D.2]: Wireless gateway > WPS.
2 In the Connect to home network screen, select OK.
[D.3] Reboot: Reset the WLAN module:
1 Go to [D.3]: Wireless gateway > Reboot.
2 In the Reboot the gateway screen, select OK.
[D.4] Device info: Consult information about the WLAN module:
1 Go to [D.4]: Wireless gateway > Device info.
2 Read out SSID, MAC address, and Serial number.
INFORMATION
Restriction: WLAN settings are only visible when a WLAN cartridge is inserted in the
user interface.
About the WLAN cartridge
The WLAN cartridge connects the system to the internet. As user you can then
control the system via the Daikin Residential Controller app.
This needs the following components:
a WLAN cartridge The WLAN cartridge needs to be inserted in the
user interface.
b Router Field supply.