Need help?Do you have a question about the Daikin Altherma 3 H HT W and is the answer not in the manual?
General| Type | Air-to-Water Heat Pump |
|---|---|
| Energy Efficiency Class (Heating) | A+++ |
| Energy Efficiency Class (Cooling) | A++ |
| Refrigerant | R-32 |
| Maximum Flow Temperature | 70°C |
| Operating Temperature Range (Cooling) | 10°C to 46°C |
| Power Supply | 3-phase, 400V, 50Hz |
| Heating Capacity | 4.0 - 16.0 kW |
| Hot Water Tank Volume | 180 - 300 L |
Details the requirements for the indoor unit installation site.
Specifies the requirements for the indoor unit installation location.
Step-by-step guide for mounting the indoor unit on the wall.
Details the process of installing the indoor unit.
Instructions for connecting the water piping.
Details the connection of water piping.
Details various connections to the indoor unit.
Instructions for connecting the main power supply.
Steps for connecting the backup heater power supply.
Instructions for connecting the shut-off valve.
Guide for connecting electricity meters.
Steps to connect the domestic hot water pump.
Connecting the safety thermostat (NC contact).
Guide for initial system setup via the configuration wizard.
Setting up the main heating/cooling zone parameters.
Pre-commissioning checks to ensure proper installation.
Steps to perform during the commissioning process.
Procedure to check the minimum flow rate.
Steps to perform an air purge.
Procedure for performing an operation test run.
To Next Page