Why Daikin Air Conditioner is not turning on? (OPERATION lamp is off)
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Ensure the breaker hasn't been turned OFF or a fuse hasn't blown. * Verify that there isn't a power failure. * Confirm that batteries are correctly installed in the remote controller. * Check if the timer setting is correct.
What to do if Daikin Air Conditioner operation stops suddenly? (OPERATION lamp is on)
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp is on, it might be due to a sudden large voltage fluctuation. For system protection, the air conditioner automatically resumes operation in about 3 minutes.
Why Daikin ARX35BVMB operation does not start soon?
If your Daikin Air Conditioner doesn't start immediately after pressing the ON/OFF button soon after stopping or reselecting the mode, wait for about 3 minutes.
Why Daikin ARX35BVMB Air Conditioner outdoor unit emits water or steam?
The outdoor unit of your Daikin Air Conditioner may emit water or steam. This can occur in HEAT mode when frost on the outdoor unit melts during defrost operation. In COOL or DRY mode, moisture in the air can condense on the cool surface of the outdoor unit piping and drip.
How to improve cooling (heating) effect of Daikin Air Conditioner?
If you're experiencing poor cooling or heating with your Daikin Air Conditioner, consider these points: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify that the temperature setting is appropriate. * Confirm that windows and doors are closed. * Check if the airflow rate and direction are set correctly. * Check if the unit is set to the INTELLIGENT EYE mode.
Why my Daikin ARX35BVMB smells bad?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's likely due to smells from the room, furniture, or cigarettes being absorbed into the unit and discharged with the airflow. If this occurs, it is recommended to have the indoor unit cleaned by a technician.
Why Daikin Air Conditioner hot air does not flow out soon after the start of heating operation?
If hot air doesn't flow out immediately after starting the heating operation on your Daikin Air Conditioner, allow 1 to 4 minutes for the system to warm up. The system is designed to discharge air only after reaching a certain temperature.
Why Daikin ARX35BVMB heating operation stops suddenly and a flowing sound is heard?
If the heating operation on your Daikin Air Conditioner stops suddenly and you hear a flowing sound, the system is likely removing frost from the outdoor unit. Wait for about 3 to 8 minutes.
Why does Daikin Air Conditioner release mists from the indoor unit?
Mists may come out of the indoor unit of your Daikin Air Conditioner when the air in the room is cooled into mist by the cold airflow during cooling operation.
General| Brand | Daikin |
|---|---|
| Model | ARX35BVMB |
| Category | Air Conditioner |
| Language | English |
Details specifications for cooling only models (230V, 50Hz).
Details specifications for cooling only models (230V, 50Hz).
Details specifications for heat pump models (230V, 50Hz).
Details wiring diagram for indoor unit PCBs and connectors.
Details wiring diagram for indoor unit PCBs and connectors.
Details wiring diagram for outdoor unit PCBs and connectors.
Explains the inverter compressor frequency control principle.
Explains the inverter compressor frequency control principle.
Details compressor frequency adjustment logic.
Explains protection against indoor heat exchanger freezing.
Details the defrost operation logic and conditions.
Explains the logic for controlling the electronic expansion valve.
Lists and explains detected system malfunctions and error codes.
Lists essential safety warnings and cautions.
Lists essential safety warnings and cautions.
Lists common issues and their causes/solutions.
Lists symptoms and corresponding checks/solutions.
Lists error codes and their meanings.
Lists error codes and their meanings.
Explains indoor unit PCB malfunction.
Details freeze-up and high pressure protection.
Explains fan motor issues.
Explains indoor thermistor issues.
Explains communication errors.
Explains compressor overload protection.
Explains compressor lock issues.
Explains input over current detection.
Explains four-way valve issues.
Explains discharge pipe temp control.
Explains position sensor issues.
Explains CT sensor issues.
Explains outdoor thermistor issues.
Explains electrical box temp rise.
Details how to check the EV.
Details how to check the four way valve.
Details how to check thermistor resistance.
To Next Page
