Need help?Do you have a question about the Daikin ATC60RRV162 and is the answer not in the manual?
Procedure to remove air filters, including unfastening hooks and removing optional filters.
Instructions for removing the front panel by releasing shafts and pushing them into position.
Steps to remove the horizontal blade by releasing center and left shafts.
Procedure to unfasten hooks and remove vertical blade ASSYs using a flat screwdriver.
Steps to remove the front grille by removing screws and unfastening hooks.
Removing service cover, terminal board screws, wire fixture, and disconnecting connecting wire.
Unfastening hooks to detach and remove the electrical box cover.
Removing thermistor, disconnecting connectors, and detaching the electrical box.
Procedure to remove the control PCB, including terminal board and connector disconnection.
Unfastening hooks and disconnecting connectors to remove the display/signal receiver PCB ASSY.
Procedure to remove the swing motor by unscrewing it from its mounting.
Handling drain hose, unscrewing piping, and detaching unit from installation plate.
Steps to remove the indoor heat exchanger by releasing side screws and hooks.
Removing the right side plate and the screw securing the fan rotor.
Unfastening bottom frame ASSY hook and releasing fan rotor from left groove.
Procedure for removing the fan motor, including reassembly notes on play and screw tightening.
Procedure to remove air filters, including unfastening hooks and removing optional filters.
Instructions for removing the front panel by releasing shafts and pushing them into position.
Steps to remove the horizontal blade by releasing center and left shafts.
Procedure to unfasten hooks and remove vertical blade ASSYs using a flat screwdriver.
Steps to remove the front grille by removing screws and unfastening hooks.
Removing service cover, terminal board screws, wire fixture, and disconnecting connecting wire.
Unfastening hooks to detach and remove the electrical box cover.
Removing thermistor, disconnecting connectors, and detaching the electrical box.
Procedure to remove the control PCB, including terminal board and connector disconnection.
Unfastening hooks and disconnecting connectors to remove the display/signal receiver PCB ASSY.
Procedure to remove the swing motor by unscrewing it from its mounting.
Handling drain hose, unscrewing piping, and detaching unit from installation plate.
Steps to remove the indoor heat exchanger by releasing side screws and hooks.
Removing the right side plate and the screw securing the fan rotor.
Unfastening bottom frame ASSY hook and releasing fan rotor from left groove.
Procedure for removing the fan motor, including reassembly notes on play and screw tightening.
General| Brand | Daikin |
|---|---|
| Model | ATC60RRV162 |
| Category | Air Conditioner |
| Language | English |
To Next Page
