Why Daikin Air Conditioner is not turning on? (OPERATION lamp is off)
If your Daikin Air Conditioner isn't turning on and the OPERATION lamp is off, check the following: * Ensure the breaker hasn't been turned OFF or a fuse hasn't blown. * Verify that there isn't a power failure. * Confirm that batteries are correctly installed in the remote controller. * Check if the timer setting is correct.
What to do if Daikin Air Conditioner operation stops suddenly? (OPERATION lamp is on)
If your Daikin Air Conditioner stops suddenly and the OPERATION lamp is on, it might be due to a sudden large voltage fluctuation. For system protection, the air conditioner automatically resumes operation in about 3 minutes.
Why Daikin ATK35BVMB Air Conditioner operation does not start soon?
If your Daikin Air Conditioner doesn't start immediately after pressing the ON/OFF button soon after stopping or reselecting the mode, wait for about 3 minutes.
Why Daikin Air Conditioner outdoor unit emits water or steam?
The outdoor unit of your Daikin Air Conditioner may emit water or steam. This can occur in HEAT mode when frost on the outdoor unit melts during defrost operation. In COOL or DRY mode, moisture in the air can condense on the cool surface of the outdoor unit piping and drip.
How to improve cooling (heating) effect of Daikin ATK35BVMB Air Conditioner?
If you're experiencing poor cooling or heating with your Daikin Air Conditioner, consider these points: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify that the temperature setting is appropriate. * Confirm that windows and doors are closed. * Check if the airflow rate and direction are set correctly. * Check if the unit is set to the INTELLIGENT EYE mode.
Why my Daikin Air Conditioner smells bad?
If your Daikin Air Conditioner's indoor unit is emitting an odor, it's likely due to smells from the room, furniture, or cigarettes being absorbed into the unit and discharged with the airflow. If this occurs, it is recommended to have the indoor unit cleaned by a technician.
Why Daikin ATK35BVMB hot air does not flow out soon after the start of heating operation?
If hot air doesn't flow out immediately after starting the heating operation on your Daikin Air Conditioner, allow 1 to 4 minutes for the system to warm up. The system is designed to discharge air only after reaching a certain temperature.
Why Daikin ATK35BVMB Air Conditioner heating operation stops suddenly and a flowing sound is heard?
If the heating operation on your Daikin Air Conditioner stops suddenly and you hear a flowing sound, the system is likely removing frost from the outdoor unit. Wait for about 3 to 8 minutes.
Why does Daikin ATK35BVMB Air Conditioner release mists from the indoor unit?
Mists may come out of the indoor unit of your Daikin Air Conditioner when the air in the room is cooled into mist by the cold airflow during cooling operation.
Lists operational functions for cooling and heat pump modes.
Lists functions specific to the cooling-only operation mode.
Lists functions specific to the heat pump operation mode.
Provides technical data for cooling and heat pump models.
Detailed specifications for cooling-only models.
Detailed specifications for heat pump models.
Details wiring connections for indoor and outdoor units.
Wiring diagram and connector identification for the indoor unit.
Wiring diagram and connector identification for the outdoor unit.
Explains core operational functions like frequency control and auto-swing.
Describes how the inverter controls frequency for capacity regulation.
Details the human motion sensor function for energy saving.
Explains the role of key components like the four-way valve.
Outlines system control logic, including mode hierarchy.
Details the process of determining compressor frequency based on conditions.
Lists operational functions for cooling and heat pump modes.
Lists functions specific to the cooling-only operation mode.
Lists functions specific to the heat pump operation mode.
Provides technical data for cooling and heat pump models.
Detailed specifications for cooling-only models.
Detailed specifications for heat pump models.
Details wiring connections for indoor and outdoor units.
Wiring diagram and connector identification for the indoor unit.
Wiring diagram and connector identification for the outdoor unit.
Explains core operational functions like frequency control and auto-swing.
Describes how the inverter controls frequency for capacity regulation.
Details the human motion sensor function for energy saving.
Explains the role of key components like the four-way valve.
Outlines system control logic, including mode hierarchy.
Details the process of determining compressor frequency based on conditions.
General| Model | ATK35BVMB |
|---|---|
| Category | Air Conditioner |
| Brand | Daikin |
| Type | Wall Mounted |
| Cooling Capacity | 3.5 kW |
| Energy Efficiency Ratio (EER) | 3.21 |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Outdoor Unit Noise Level | 48 dB(A) |
| Outdoor Unit Dimensions (HxWxD) | 550x765x285 mm |
To Next Page
