Need help?Do you have a question about the Daikin ATKC18RV2S and is the answer not in the manual?
Steps to detach the primary air filters from the indoor unit.
Procedure for detaching the special Titanium apatite photocatalytic air-purifying filters.
Procedure to open, release shafts, and remove the front panel.
Steps to unscrew and unhook the front grille for removal.
Process to release shafts and remove both large and small horizontal blades.
Procedure to release shafts and hooks to detach vertical blade assemblies.
Steps to remove service cover, drip plate, thermistor, and earth wire.
Procedure to disconnect harnesses and remove the main electrical box.
Steps to detach the shield plate and signal receiver unit.
Procedure to unfasten hooks and remove the display PCB.
Disconnecting connectors and removing intelligent eye and signal receiver PCBs.
Procedure to disconnect harnesses and remove the main control PCB.
Steps to remove the swing motor assembly for horizontal blades.
Procedure to remove the swing motor assembly for vertical blades, including drain hose.
Procedure to detach the swing motor unit by removing screws and hooks.
Steps to disconnect refrigerant piping and drain hose before removal.
Procedure to detach the indoor unit from its mounting plate.
Procedure to remove auxiliary piping and the indoor heat exchanger.
Steps to remove side plates and fan motor fixing plate.
Procedure to remove the fan motor and fan rotor assemblies.
Procedure to remove the fan rotor and its rubber bearing.
Steps to detach the primary air filters from the indoor unit.
Procedure for detaching the special Titanium apatite photocatalytic air-purifying filters.
Procedure to open, release shafts, and remove the front panel.
Steps to unscrew and unhook the front grille for removal.
Process to release shafts and remove both large and small horizontal blades.
Procedure to release shafts and hooks to detach vertical blade assemblies.
Steps to remove service cover, drip plate, thermistor, and earth wire.
Procedure to disconnect harnesses and remove the main electrical box.
Steps to detach the shield plate and signal receiver unit.
Procedure to unfasten hooks and remove the display PCB.
Disconnecting connectors and removing intelligent eye and signal receiver PCBs.
Procedure to disconnect harnesses and remove the main control PCB.
Steps to remove the swing motor assembly for horizontal blades.
Procedure to remove the swing motor assembly for vertical blades, including drain hose.
Procedure to detach the swing motor unit by removing screws and hooks.
Steps to disconnect refrigerant piping and drain hose before removal.
Procedure to detach the indoor unit from its mounting plate.
Procedure to remove auxiliary piping and the indoor heat exchanger.
Steps to remove side plates and fan motor fixing plate.
Procedure to remove the fan motor and fan rotor assemblies.
Procedure to remove the fan rotor and its rubber bearing.
General| Cooling Capacity | 1.5 Ton |
|---|---|
| Star Rating | 3 Star |
| Refrigerant | R32 |
| Weight (Outdoor Unit) | 34 kg |
| Type | Split AC |
| Energy Efficiency Ratio (Heating) | 3.8 W/W |
| Outdoor Unit Dimensions (W x H x D) | 300 mm |
| Power Supply | 230 V, 50 Hz |
| Annual Energy Consumption (Heating) | Not Applicable |
To Next Page