6 English
Sheath part in the remote controller case should be stripped.
Peel the shield and sheath
Cutting guideline
of the wiring
Ca. 10mm
For easy wiring, it is better to
keep ca. 10mm difference
between the length of two wires.
Sheath stripping length:
Ca. 150mm for upper outlet ●
Ca. 200mm for upper center outlet ●
Connect the terminals (P/P1, N/P2) of the remote controller upper case with the terminals (P1, P2)
of the indoor unit. (P1 and P2 have no polarities.)
Back outlet3-5-1
<Wiring fixing guideline>
Lower case
P1
Indoor unit
P2
Upper case
PC-board
Clamp
Wiring fixing
point
Cross-section -
Secure the wiring at
the wiring fixing point
by using attached
clamping material.
Clamp
01_EN_EM08A086.indd 601_EN_EM08A086.indd 6 4/7/2009 7:32:09 PM4/7/2009 7:32:09 PM
To Next Page
Loading...
Need help?
General
