English 9
Operation mode selector button1.
Press this button to select the operation ●
mode of your preference. (See page 14.)
Available modes vary with the connecting *
model.
Fan speed control button2.
Press this button to select the fan speed of ●
your preference. (See page 15.)
Available fan speed vary with the*
connecting model.
Menu/Enter button3.
Used to indicate the main menu. ●
(See page 24 for the menu items.)
Used to enter the setting item selected. ●
Up button 4. (Be sure to press the
part with the symbol )
Used to raise the set temperature. ●
The next items on the upper side will be ●
highlighted.
(The highlighted items will be scrolled
continuously when the button is kept
pressed.)
Used to change the item selected. ●
Down button 5. (Be sure to press
the part with the symbol )
Used to lower the set temperature. ●
The next items on the lower side will be ●
highlighted.
(The highlighted items will be scrolled
continuously when the button is kept
pressed.)
Used to change the item selected. ●
Right button 6. (Be sure to press
the part with the symbol )
Used to highlight the next items on the ●
right-hand side.
Each screen is scrolled in the right-hand ●
direction.
Home leave settings are enabled with this ●
button kept pressed for at least four
seconds. (See page 19.)
Left button 7. (Be sure to press
the part with the symbol )
Used to highlight the next items on the ●
left-hand side.
Each screen is scrolled in the left-hand ●
direction.
Home leave settings are enabled with this ●
button kept pressed for at least four
seconds. (See page 19.)
On/Off button8.
Press this button and system will start. ●
Press this button again and system will ●
stop.
Operation lamp (Green)9.
This lamp lights up during operation. ●
This lamp blinks if a error occurs. ●
Cancel button10.
Used to return to the previous screen. ●
LCD (with backlight)11.
The backlight will be light for approximately ●
30 seconds by pressing any operation
button. Operate buttons excluding the On/
Off button while the backlight is lit.
If two remote controllers are used to control ●
a single indoor unit, the backlight of the
remote controller operated earlier than the
other one will be lit.
01_EN_3P243520-1B.indd 901_EN_3P243520-1B.indd 9 5/15/2009 10:21:01 AM5/15/2009 10:21:01 AM