English 8
AUTOMATIC OPERATION ................“ ”
• In this operation mode, COOLING/
HEATING changeover is automatically
conducted.
•
The AUTOMATIC OPERATION controls
the temperature based on the tempera-
ture setting, so it maintains a comfortable
temperature throughout the year, and
enables energy-saving operation.
<Example>
When the indoor temperature decreases
to 25°C or less when the temperature
setting is at 27°C in the AUTOMATIC
COOLING OPERATION, the operation
is changed over to the AUTOMATIC
HEATING OPERATION. When the
indoor temperature reaches 29°C or
more, the operation is changed over to
the AUTOMATIC COOLING OPERA-
TION.
FAN OPERATION..............................“ ”
Air in the room is circulated.
PROGRAM DRY OPERATION..........“ ”
• The function of this program is to
decrease the humidity in your room with
the minimum temperature decrease.
• Micro computer automatically deter-
mines TEMPERATURE and FAN
SPEED.
• This system does not go into operation if
the room temperature is below 16°C.
ON/OFF
Press ON/OFF BUTTON
OPERATING INDICATOR LAMP (Red) lights
up or goes off and the system starts or stops
OPERATION.
• When the HEATING OPERATION is
stopped, FAN OPERATION is performed
for 1 minute to remove heat in the indoor
unit.
2
ON OFF
NOTE
• Do not turn OFF power immediately after
the unit stops. Then, wait no less than 5
minutes.
Water is leaking or there is something else
wrong with the unit.
• After settings are changed or operation is
turned ON/OFF, make sure that the receiv-
ing tone of the indoor unit makes a beep-
ing sound.
[CHARACTERISTICS OF THE COOL-
ING OPERATION (COOLING OPERA-
TION AND AUTOMATIC COOLING
OPERATION)]
• After continued operation at a downward
airflow direction, operate the air condi-
tioner using a different direction setting for
a period of time to prevent condensation
on the airflow flaps. (The remote controller
displays the airflow direction that is set.)
• If the COOLING OPERATION is used
when the indoor temperature is low, frost
adheres to the heat exchanger of the
indoor unit. This can decrease the cooling
capacity. In this case, the system automat-
ically switches to DEFROST OPERATION
for a while.
During DEFROST OPERATION, the low
airflow rate is used to prevent the dis-
charge of melt water. (The remote control-
ler displays the airflow rate that is set.)
• When the outside temperature is high, it
takes some time until the outside tempera-
ture reaches the set temperature.
[CHARACTERISTICS OF THE HEAT-
ING OPERATION (HEATING OPERA-
TION AND AUTOMATIC HEATING
OPERATION)]
START OF OPERATION
• It generally takes a longer time for
HEATING OPERATION to reach the set
temperature compared to COOLING
OPERATION. It is advisable to start
operation in advance using TIMER
OPERATION.
01_EN_3P302565-1.fm Page 8 Monday, February 13, 2012 4:09 PM
To Next Page
Loading...
