Why is the cooling (heating) effect of my Daikin CTXS35K2V1B poor?
If your Daikin Air Conditioner's cooling or heating effect is poor, check the following: * Ensure the air filters are clean. * Make sure nothing is blocking the air inlet or outlet of the indoor and outdoor units. * Verify the temperature setting is appropriate. * Ensure all windows and doors are closed. * Confirm the airflow rate and direction are set correctly.
How to troubleshoot a Daikin Air Conditioner that does not operate (OPERATION lamp is off)?
If your Daikin Air Conditioner does not operate and the OPERATION lamp is off, check these possible causes: * See if a breaker has turned off or a fuse has blown. * Check for a power failure. * Ensure batteries are correctly installed in the remote controller. * Verify that the timer setting is correct.
Why does my Daikin Air Conditioner remote controller not work properly?
If your Daikin Air Conditioner's remote controller isn't working properly, the batteries may be low or the remote controller may be malfunctioning. Replace all batteries with new, size AAA.LR03 (alkaline) batteries.
What to do if Daikin CTXS35K2V1B operation stopped suddenly (OPERATION lamp is on)?
If your Daikin Air Conditioner stopped suddenly, but the OPERATION lamp is on, it may be due to a system protection triggered by a sudden large voltage fluctuation. The air conditioner will automatically resume operation in about 3 minutes.
Why does mist come out of the indoor unit of my Daikin CTXS35K2V1B Air Conditioner?
The mist coming from the indoor unit of your Daikin Air Conditioner can occur for two reasons: * The air in the room is cooled into mist by the cold airflow during COOL operation. * The air in the room is cooled by the heat exchanger and becomes mist during defrost operation.
Why does my Daikin CTXS35K2V1B indoor unit give out an odor?
The odor from your Daikin Air Conditioner's indoor unit can happen when smells from the room, furniture, or cigarettes are absorbed into the unit and discharged with the airflow. If this occurs, it's recommended to have the indoor unit cleaned by a technician.
What to do if my Daikin CTXS35K2V1B operation stopped suddenly and the OPERATION lamp is flashing?
If your Daikin Air Conditioner operation stopped suddenly and the OPERATION lamp is flashing, consider the following: * Ensure the air filters are clean. Clean them if necessary. * Check for any obstructions blocking the air inlet or outlet of the indoor and outdoor units. * Turn the breaker off, remove any obstacles, and then turn it back on. Try operating the air conditioner with the remote controller again. If the lamp continues to flash, contact the service shop where you purchased the air conditioner. * If you have a multi-system, verify that all indoor units are set to the same operation mode. If not, set them all to the same mode and check if the lamps flash. If the operation mode is in AUTO, set all indoor unit operation modes to COOL or HEAT temporarily and check again. I...
Essential safety instructions and warnings for operating the air conditioner.
Identifies and describes the components of the indoor, outdoor units, and remote controller.
Steps required before initial use, including setting batteries and the clock.
Explains various operating modes like AUTO, DRY, COOL, HEAT, and FAN.
Guides on how to control the direction and speed of airflow for comfort.
Feature for comfortable airflow that avoids direct blowing on people.
Sensor-based operation for energy saving and detecting human presence.
Maximizes cooling or heating effect for a limited duration.
Reduces noise from the outdoor unit for quieter operation.
Limits maximum power consumption for efficient operation.
Sets schedules for the unit to automatically turn off.
Sets schedules for the unit to automatically turn on.
Allows setting of automatic operation schedules for each day of the week.
Specific information and considerations for multi-unit air conditioning systems.
Provides instructions for routine maintenance and cleaning of the air conditioner.
Addresses non-troubles, common problems, and initial user checks.
Explains how to use the remote controller to identify and interpret error codes.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Refrigerant | R32 |
| Energy Efficiency Ratio (EER) | 3.21 |
| Power Supply | 220-240 V, 50 Hz |
| Outdoor Unit Weight | 34 kg |
| Type | Split System |
To Next Page
