Daikin DBG Series - PRODUCT DESIGN

5
• 

   


• 



 
     

     

     

 

 



B

   MUST BE REMOVED

Please follow the instrucons below to remove brace.
         
     

        

     
CAUTION

The struts are located in the fork holes and
are used to protect the unit from damage while liing with
forks. The shipping brace is located under the unit (under
compressor).

   

LIFT OVER APPROXIMATE
CENTER OF UNIT
SPREADER BARS
MUST BE USED WITH
LIFTING STRAPS THAT
ARE LESS THAN 16
FEET L ONG
REMOVE 2 BRACKETS
ON EACH END TO
REMOVE
WOODEN STRUTS
REMOVE 2 BRACKETS
ON EACH END TO
REMOVE
SHIPPING BRACE





    






  



T O PREVENT POSSIBLE EQUIPMENT DAMAGE , PROPERTY DAMAGE ,
PERSONAL INJURY OR DEATH , THE FOLLOWING BULLET POINTS MUST BE
OBSERVED WHEN INSTALLING THE UNIT .
WARNING