What to do if the receive LED is solid green on my Daikin Furnace?
If the receive LED on your Daikin Furnace is solid green, it might be due to a short between the data 1 and data 2 wires. In this case, you should check the data 1 and data 2 voltages.
Why is the receive LED on my Daikin Furnace solid green?
If the receive LED on your Daikin Furnace is solid green, it could be because the data 1 and data 2 wires are reversed at the furnace, thermostat, or communicating compatible outdoor AC/HP. To resolve this, check the wire connections at the terminal block.
Step-by-step guide for safe operation of the appliance.
Minimum required distances from combustible materials for safe installation.
Procedure for connecting the furnace to the main power supply.
Instructions for connecting the thermostat to the furnace control.
Configuration settings for furnace operation modes and features.
Guide for testing the ECM motor using a specific diagnostic tool.
Inspection criteria for stable, quiet, soft, and blue burner flames.
Guidance for diagnosing and resolving unit operational problems.
Procedure for measuring electrical voltage at various points.
Steps to measure and verify inlet and manifold gas pressures.
Correlation between LED codes and abnormal furnace behavior.
General| Stages | Modulating |
|---|---|
| Heating Capacity | 60, 000 - 120, 000 BTU/h |
| Fuel Type | Gas |
| Blower Motor Type | ECM |
| Warranty | 12-year limited warranty on heat exchanger |
To Next Page
