PRODUCT IDENTIFICATION
7
MODEL # MFG # DESCRIPTION
AFE18-60A
N/A
Fossil Fuel Kit.
The AFE18-60A control is designed for use where the indoor coil is located above/downstream
of a gas or fossil fuel furnace when used with a heat pump. It will operate with single and two stage heat
pumps and single and two stage furnaces. The AFE18-60A control will turn the heat pump unit off when the
furnace is turned on. An anti-short cycle feature initiates a 3 minute timed off delay when the compressor goes
off.
AMU1620
AMU1625
AMU2020
AMU2025
GMU1620
GMU1625
GMU2020
GMU2025
P1251305F
P1251306F
P1251307F
P1251308F
N/A
Media Air Cleaner
. For use with modulating furnace models. The air cleaner is a high efficiency air filtration
device designed to remove dirt, dust, pollen and other microscopic particles from the air passing through it.
Flexible performance range up to 2,000 CFM capacity. The air cleaner should be installed in the system so that
all the system air is circulated through the air cleaner. The air cleaner will only remove the airborne
contaminants delivered to it. Maximum performance is obtained when the system blower is set for continuous
operation. Carbon filters (optional) are available.
ASAS-10
ASAS-11
ASAS-12
ASAS-18
P1251301F
P1251302F
P1251303F
P1251304F
Electronic Air Cleaner
. For use with variable speed, modulating furnace models. The High-Efficiency
Electronic Air Cleaner is designed to remove air contaminants down to .01 microns. Carbon filters (optional)
remove odors. Dual indicator lights show unit operation at a glance. Electronic proving switch cycles the air
cleaner On/Off with the system fan. Durable powder-coat paint finish resists corrosion.
CFSB17
CFSB21
CFSB24
N/A
Counterflow Subbase Kit
. For use with modulating 34.5" furnace models
.
These kits are available for the
following furnace widths: 17.5" wide (CFSB17), 21" wide (CFSB21) and 24" wide (CFSB24). The kits must be
used to prevent excessive temperature from reaching combustible materials, if the furnace is installed on a
combustible floor. This subbase effectively separated the furnace base and plenum from combustible
materials. To ensure safe installation, do not install the counterflow floor base directly on carpeting, tile, or
other combustible material other than wood flooring.
CTK01
CTK01AA
Communicating Thermostat Kit
- Digitally communicating touchscreen thermostat, a necessary part of any
communicating system. Designed for use with compatible Daikin Air Handlers or Furnaces and outdoor split
AC or Heat Pump units. This thermostat supports up to three stages of heat, two stages of cooling, dual fuel
applications, dehumidification, filter maintenance reminders, outdoor temperature display and advanced
menus including diagnostics. The CTK01AA kit includes a communicating touchscreen thermostat and sub
base, 230V-24V 40va transformer, terminal blocks(2), wire jumpers,
mounting screws, installation manual and homeowner guide.
CTK01BA
CTK01BA
Communicating Thermostat Kit
- Digitally communicating touchscreen thermostat, a necessary part of any
communicating system. Designed for use with compatible Daikin Air Handlers or Furnaces and outdoor split
AC or Heat Pump units. This thermostat supports up to three stages of heat, two stages of cooling, dual fuel
applications, dehumidification, filter maintenance reminders, outdoor temperature display and advanced
menus including diagnostics. The CTK01BA kit includes a communicating touchscreen thermostat and sub
base, terminal blocks(2), mounting screws, installation manual and homeowner guide.
CTK02**
CTK02**
Communicating Thermostat Kit
- Digitally communicating thermostat, a necessary part of any communicating
system. Designed for use with compatible Daikin Air Handlers or Furnaces and outdoor split AC or Heat Pump
units. The CTK02** thermostat features full color, high definition display, advanced programming options
including humidification control & heat and cool maximum temperature settings, a USB plug allowing dealers
the ability to insert pre-programmed operating parameters and dealer information by use of an online data
entry system.
CTK03A*
CTK03A*
Communicating Thermostat Kit
- Digitally communicating touchscreen thermostat from Honeywell. Designed
for use with compatible Daikin Air Handlers or Furnaces and outdoor split AC or Heat Pump units. The
CTK03A* thermostat features full color high definition display, can be used with RedLINK wireless
accessories.
CTK04A*
CTK04A*
Communicating Thermostat Kit
- Digitally communicating touchscreen thermostat from Honeywell. Designed
for use with compatible Daikin Air Handlers or Furnaces and outdoor split AC or Heat Pump units. The
CTK04A* thermostat features full color high definition display, can be used with RedLINK wireless
accessories. Split system inverter capable.