ESIE10-01 General Outline
Part 1 – System Outline 1–39
3
1
4
5
Notes (1) Cooling capacity, unit power input in cooling and EER are based on the following conditions:
evaporator 12/7°C; ambient 35°C, unit at full load operation.
(2) The values are according to ISO 3744 and are referred to: evaporator 12/7°C, ambient 35°C, full
load operation.
Safety devices High discharge pressure (pressure switch)
High discharge pressure (pressure transducer)
Low suction pressure (pressure transducer)
Compressor motor protection
High discharge temperature
Low oil pressure
Low pressure ratio
High oil filter pressure drop
Phase monitor
Emergency stop button
Water freeze protection controller
Model EWAD~C-PL
820 890 980 C11 C12 C13 C14
To Next Page
Loading...
