Daikin FBQ50D - Page 135

ESIE15-13C Troubleshooting by Remote Controller
Service Diagnosis 121
Normal status
Enters inspection mode from normal status
when the INSPECTION/ TEST button is
pressed.
1 Press INSPECTION/TEST button.
If no button is pressed for 1
minute, equipment returns to
normal status.
When MODE selector
button is pressed or no
button is pressed for 1
minute, equipment returns
to normal status.
If no button is pressed for 1
minute, equipment returns to
normal status.
5 Press MODE selector button.
3 Press
MODE
selector
button.