To Next PageTo Next Page
Need help?Do you have a question about the Daikin FDMA125AV16 and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Model | FDMA125AV16 |
| Cooling Capacity | 12.5 kW |
| Heating Capacity | 14.0 kW |
| Refrigerant | R32 |
| Indoor Unit Dimensions (WxHxD) | 800x295x223 mm |
| Outdoor Unit Dimensions (WxHxD) | 780x550x285 mm |
Explains the meaning of WARNING and CAUTION symbols used in the manual.
Important information regarding the refrigerant used (R32).
Instructions for safely transporting the indoor unit.
Lists the necessary parts required for installation.
Lists and describes the accessories provided with the indoor unit.
Information on optional accessories for the indoor unit.
Items to verify after the installation work is completed.
Conditions and criteria for selecting the installation site.
Required clearances for installation and maintenance of the unit.
Checking ceiling openings and preparing for hanging bolts.
Instructions for installing hanging bolts for unit support.
Steps for temporarily installing the indoor unit using brackets.
Adjusting the unit for proper position and horizontality.
Warnings and instructions for tightening flare nuts correctly.
Guidelines for insulating the refrigerant piping to prevent issues.
Instructions for installing drain piping to ensure proper drainage.
Warnings regarding drain piping, such as stagnation and supports.
Specific cautions for upward drain piping installation.
Instructions for connecting air ducts, including insulation and sealing.
General instructions and safety precautions for electrical wiring.
Specifications for field supply fuses and wiring components.
Cautions regarding wiring connections, terminal blocks, and tightening.
Instructions for removing and handling the control box lid safely.
Procedures for connecting wires into the control box.
Steps for performing wiring inside the control box.
Sealing openings around wires to prevent ingress of animals or moisture.
Installing wire fixing brackets and clamps for securing wires.
Examples of wiring configurations for different system types.
Steps and cautions for performing field settings on the unit.
Adjusting settings for external static pressure and air volume.
Settings related to attached optional accessories.
Adjusting fan speed settings, especially during thermostat-off states.
Configuring the air filter cleaning indication time.
Settings for forced stop or start-stop control via remote.
Settings for connecting multiple indoor units in a simultaneous operation system.
Step-by-step guide for setting up master and slave units individually.
Performing test operation and diagnosing problems using the remote controller.
A table listing malfunction codes, descriptions, and remarks.
Additional notes regarding malfunction codes and system behavior.
Important cautions to observe after test operation completion.
Guidance for the operator performing test operation.
Step-by-step instructions for unpacking the indoor unit.
Step-by-step instructions for packing the indoor unit.
Step-by-step instructions for unpacking the outdoor unit.
Step-by-step instructions for packing the outdoor unit.
