Daikin FFQ35B9V1B - Preparation before Operation

SiBE121135 RA Indoor Unit
Operation Manual 139
2.1.3 Preparation before Operation
+
2
3
1
Remote controller
Screws
Preparation before Operation
 To set the batteries
 To fix the remote controller holder on the wall
 To set the luminance of the display
• The luminance of the indoor unit display can be set.
Press .
Hi Low Off
NOTE
1. Choose a place from where the signals
reach the unit.
2. Fix the holder to a wall, a pillar, or similar
location with the screws procured locally
3. Place the remote controller in the remote
controller holder.
1. Slide the front cover to take it off.
2. Set two dry batteries AAA.LR03 (alkaline).
3. Set the front cover as before.
Position and
– correctly!
Remote
controller holder
 Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace both old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately 1 year. If the remote controller display begins to fade and the degradation of reception performance
occurs within a year, however, replace both batteries with new, size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
 Notes on remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult the
shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the service shop.