RA Indoor Unit SiBE121135
166 Operation Manual
FVXG25/35/50K2V1B
ON TIMER Operation
Display
Present time: 23:00 (The unit operating)
Combined
(Example)
NOTE
To use ON TIMER operation
• Check that the clock is correct.
If not, set the clock to the present time.
1.
Press .
• “ ” is displayed on the LCD.
• “ ” blinks.
• “ ” and day of the week disappear from the LCD.
2.
Press until the time setting reaches the
point you like.
• Each pressing of either button increases or decreases the time setting by 10 minutes.
Holding down either button changes the time setting rapidly.
3.
Press again.
• “ ” and setting time are displayed on the LCD.
• The OPERATION lamp blinks and the TIMER lamp lights yellow.
To cancel ON TIMER operation
Press .
• “ ” and setting time disappear from the LCD.
• “ ” and day of the week are displayed on the LCD.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
OFF TIMER at 0:00
ON TIMER at 14:00
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
To Next Page
Loading...
