Heat exchanger fin
Hydrophilic film
Aluminium
Corrosion-resistant
acrylic resin
Figures are for FT50/ 60G.
Figures are for FT25/35G.
Malfunction codes are shown on the digital
display panel of the wireless remote
controller for fast and easy maintenance.
The outdoor unit’s heat exchanger fins
are processed using a special
anticorrosion treatment. The surface is
covered with a thin acrylic resin layer to
enhance the fins’ resistance to acid rain and
salt corrosion. A hydrophilic film layer also
prevents rust caused by the run off of water
droplets. Additional durability is provided by a
rustproof steel sheet on the bottom of the unit.
Cross section of anticorrosion-treated fin
Selects fan speed
Selects mode:
cooling, dry, fan-only operation
Cancels On/Off Timer
24-Hour On Timer
24-Hour Off Timer
and Night Set Mode
Sets timer
Displays time
On/Off switch
Sets room temperature
There is a second On/Off switch on the
body of the indoor unit to prevent any
problems if the wireless remote
controller is misplaced.
Indoor Unit On/Off Switch
FT25/35G appearance
Vertical Auto-Swing
(up and down)
Wireless remote controller for FT25/35G
FT50/60G supports a piping length of up to 30
metres to give flexibility during unit installation.
This allows the outdoor unit to be placed on a
balcony or where it can not be seen. Indoor units
can also be installed where they do not
compromise the decor of a room.
New Powerful Operation
Selects fan speed
Selects mode:
cooling, dry, fan-only operation
Cancels On/Off Timer
24-Hour On Timer
24-Hour Off Timer
and Night Set Mode
Sets timer
Displays time
On/Off switch
Sets room temperature
Vertical Auto-Swing
(up and down)
Horizontal Auto-Swing
(left and right)
Wireless remote controller for FT50/60G
New Powerful Operation
98
To Next Page
