Check the units
Check that the base, stand and other fi ttings of the outdoor unit are not decayed or corroded.
Check that nothing blocks the air inlets and the outlets of the indoor unit and the outdoor unit.
Check that the drain comes smoothly out of the drain hose during COOL or DRY operation.
If no drain water is seen, water may be leaking from the indoor unit. Stop operation and consult the service shop if this is the •
case.
Before a long idle period
Operate the “FAN only” for several hours on a fi ne day to dry 1.
out the inside.
Press • and select “ ” operation.
Press •
and start the operation.
After operation stops, turn off the breaker for the room air 2.
conditioner.
Clean the air fi lters and set them again.
3.
Take out batteries from the remote controller.4.
When a multi outdoor unit is connected, make sure the heating operation is not used at the other room before you •
use the fan operation.
Page 28
01_EN_3P266960-1A.indd 3401_EN_3P266960-1A.indd 34 6/1/2011 9:16:52 AM6/1/2011 9:16:52 AM
To Next Page
Loading...
Need help?
General
