Need help?Do you have a question about the Daikin FTKD25GVM9 and is the answer not in the manual?
General| Brand | Daikin |
|---|---|
| Model | FTKD25GVM9 |
| Category | Air Conditioner |
| Language | English |
Steps to detach and remove the main air filters from the indoor unit.
Steps to detach and remove special air-purifying filters.
Procedure for opening the front panel and releasing it from the unit.
Steps for releasing and removing the front panel's left and right rotary shafts.
Removing screw covers and screws that secure the front grille.
Releasing the hooks that attach the front grille to the unit.
Final steps to detach and remove the front grille assembly.
Steps to unfasten and remove the horizontal air direction blades.
Procedure for unfastening and removing the vertical air direction blade assemblies.
Detaching wires from the terminal board and disconnecting electrical connectors.
Removing the protective drip proof plate from the electrical box area.
Final steps to disconnect and remove the main electrical box assembly.
Accessing PCBs by removing the shield plate and releasing thermistor wires.
Steps to remove the terminal board and signal receiver unit.
Detaching and removing the signal receiver printed circuit board.
Detaching and removing the INTELLIGENT EYE sensor printed circuit board.
Steps to detach and remove the display and control printed circuit boards.
Steps to detach and remove the drain pan from the indoor unit.
Steps to detach and remove the swing motor.
Steps to unfasten and remove the crank assembly.
Releasing lead wires and removing side plates and fixing plate screws.
Steps to detach and remove the fan motor fixing plate.
Final steps to detach and remove the fan motor assembly.
Removing screws that secure the indoor heat exchanger.
Disconnecting refrigerant pipings and removing the indoor unit from its mounting plate.
Releasing piping fixtures and hooks to finally remove the heat exchanger.
Removing side plates and the fan motor fixing plate.
Steps to detach and remove the fan motor and fan rotor assembly.
Removing the left side plate and the bearing.
To Next Page
